How to Get to the Command Line on a Mac. This wikiHow teaches you how to open the Terminal (command prompt) application in macOS using Launchpad, Spotlight, or Finder.![]() How to Change Your IP Address From the Command Line in Linux. Almost everybody can figure out how to change their IP address using an interface, but did you know you can set your network card’s IP address using a simple command from the command line? This trick should work on all Debian- based Linux distros, including Ubuntu. To get started, type ifconfig into the terminal and hit Enter, take note of the name of the interface that you want to change the settings for. To change the settings, you also use the ifconfig command, this time with a few parameters: sudo ifconfig eth. That’s about all all you need to do to change your IP. Of course, the above command assumes a few things: The interface that you want to change the IP for is eth. The IP you want to give the interface is 1. The Subnet Mask you want to set for the interface is 2. If you run ifconfig again, you will see that your interface has now taken on the new settings you assigned to it. If you wondering how to change the Default Gateway, you can use the route command. This will set your Default Gateway on the eth. ![]() Over the year’s I’ve had numerous occasions arise when I needed to change the MTU on a Windows based computer. There are a million reasons why this is needed. · Edit Article wiki How to Refresh Your IP Address on a Windows Computer. Two Methods: Using the Command Prompt Rebooting your Home Network Community Q&A. How do I connect to UIC-WiFi using Mac OS X 10.5 or 10.6? How do I connect to UIC-WiFi using Windows? How do I use SSH and SFTP on Mac OS X? How do I change my password? To see your new setting, you will need to display the routing table. That’s all there is to it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
October 2017
Categories |